Epson Workforce 1100 Refillable Damper Cartridge Chip Resetting RATF Chip
Our NEW RATF reset all to full chip resetting video, available for ALL Epson desktops.
This new video will show you WHEN and HOW to reset the chip (in place AND WITHOUT removal from the printer).
Whether you have the Epson Workforce 1100 or some OTHER Epson model the resetting technique is very similar.
a) an out of ink error "red X-unrecognized error"
b) ink button OR OK button presses to position the head to the change position
c) movement of switch(es) to reset position
d) completion of cart change procedure (chip in reset will error out ALL positions) by INK or OK button
e) ink OR OK button presses to position head to change position
f) movement or switch or switches to run position
g) completion of cart change procedure (chip in reset will error out ALL positions) by INK or OK button
h) printer will charge and ink light or errors on lcd will extinguish.
i) you should perform nozzle checks after every reset as well as during normal use to inspect for any defects.
It is important to remember that the RATF chip is not a reset "when you want to chip", it requires an "out of ink condition" to be exhibited prior to performing the chip reset. So wait for a red "x" (as in the video) before performing the reset. Also if you have a cartridge based refill system, you will want to refill the cartridges during the resetting procedure. You will want to refill all positions as you will be resetting all positions back to full at the same time.
|Posted : Ross Hardie - Sat, Jan 9, 2010 8:10 AM. This article has been viewed 22263 times.|
|Online URL: https://www.inkjetcarts.us/support/article/epson-workforce-1100-refillable-damper-cartridge-chip-resetting-ratf-chip-17.html|